Weld prep. I learned to not use flap disks except for very light duty like scale removal. Otherwise you smoke through them at $5 each.
Gusset added:
Tacks at this angle were very tricky to pull off:
Ready to clean, paint and install.
Friday, August 1, 2014
engine mount #1 done
As some of you know I nearly broke my arm with a 2x4 that got spun by the drill press a couple weeks back. I bought a vice to prevent the drill press from finishing the job. The unexpected benefit was that now I have a free hand to spray oil while cutting and it goes much quicker now with less heat.
fit up:
Weld prep. I learned to not use flap disks except for very light duty like scale removal. Otherwise you smoke through them at $5 each.
Gusset added:
Tacks at this angle were very tricky to pull off:
First weld that does something important (holds the engine in the car). Great that I got a good one.
Weld prep. I learned to not use flap disks except for very light duty like scale removal. Otherwise you smoke through them at $5 each.
Gusset added:
Tacks at this angle were very tricky to pull off:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment