I have been designing the transmission mount. I had a bunch of ideas, but I couldn't decide which way I wanted to go until earlier this evening. I will have to make a part on the Lathe.
Oh yeah the Lathe. I got it a while back and haven't needed it yet. I have to switch the power to a two gang box, and I need Lathe tooling.
Tonight I finally went for it and ordered the tooling I need. I saw my choices as:
MSC
Enco
Shars
CDCO
In the order of decreasing price and selection. I went with Enco and found some good deals and I think I have what I need to get going for less than $200.
-Dial test indicator
-Some center drills
-Boring bar set
-Some indexable turning tools and inserts
-Cutoff blades
I am going back out to swap out the box this evening. I will show my tranny mount designs in another post.
No comments:
Post a Comment