DS trans mount complete

Stuff from Eastwood got here a day early:

Least sexy $80 ever spent on my car, but needed for a quality job.  I finished up burning the insulation off the floor with the flap disk.  Turns out once you are burnt into that coating a razor scraps it off pretty clean:

 Primed:

These are ugly welds.  It was really hard to get my head where I could see.  Really hard to get any reasonable gun angle.  Really hard not to burn through, really hard to weld through the primer.  I found I had to set for the 18ga for the edges to have a chance.  Probably should have used the .024 wire.

Turned out nice from below.

We'll see how far the PS goes tomorrow